Z-Uno is the first and only easy to use developer board that allows you to create your own Z-Wave device without deep knowledge of Z-Wave protocol or programming.
Z-Uno is a mix of Z-Wave home automation radio protocol power and Arduino simplicity.
It is made for those who are limited by existing choice of Z-Wave products and wants to extend their smart homes with more sensors and actuators: connect LEDs, buttons, switches, motors or any low voltage sensor including most of Arduino compatible sensors. Z-Uno programming is done by writing sketch in simplified C language and loaded into Z-Uno using Arduino IDE.
Z-Uno is the perfect companion for you RaZberry 7 gateway. It's compatible with other controllers too: among them Fibaro Home Centre 2/3/Lite/Lite 2, Yubii Home, Vera Edge.

Unveil your imagination to create:
battery powered in-wall remote switch
rotary dimmer control
temperature/soil humidity/luminosity/voltage/distance or any other sensors as well as dry contact sensor or tick counter
low voltage switch
IR blaster
LED driver
motor driver
battery powered keypad
converter from any protocol to Z-Wave (using SPI/UART/I2C/1-wire bus)
Hardware specification:
174 kB Flash memory for your sketches
16 kB RAM available
Z-Wave RF transmitter at 9.6/40/100 kbps
Long Range
26 GPIO (overlaps with special hardware controllers)
4 ADC
4 PWM
2 UART
1 USB (serial port)
3 kB pseudo EEPROM
1 SPI (master or slave)
4 IR controllers, 1 IR learn capability
1 TRIAC/ZEROX to control dimmer
6 Interrupts
3 Timers
I2C (software)
1-Wire (software)
8x6 Keypad Scanner (software)
2 service LED, 1 service button
1 user test LED