Specification:
Sensor: 5 Megapixels Omnivision OV5647
camera shot: 1/4 5M
Aperture: 2.9
focal length: 3.29
FOV: 72.4
Preferred Sensor Resolution: 1080p
Support 3.3V power output
Still picture resolution: 2592 x 1944, also supports 1080p30, 720p60 and 640x480p60/90 video.
Module Size: 25x24x9mm/0.98x0.94x0.35in
Ribbon Length: 6 inch

Features:
This Camera Module is a custom designed easy plug and play for Raspberry Pi.
It attaches to for Raspberry Pi by way of one of the two small sockets on the board upper surface.

Use steps:
You should install the Raspberry Pi system, the system can be chosen, compatible with most mirror systems.
2.Enter the Raspbian system terminal.
3.Use raspi-config to configure the camera. Execute the sudo raspi-config
4.Move the cursor to the option Enable Camera, click Enter.
5.Select YES, click Enter and OK.
6.Select Finish to exist.
7.Select to reboot the system, Click Yes.
8.Enter the system terminal again, and set the photograph and photography.
1）For photograph, on the terminal execute the statement below，123.jpg is the name of picture, which can be set.
2）Generate a picture taken by the camera, you can use WinSCP software to export the picture.
3）For photography, on the terminal execute the statement below. raspivid -o 1234.h264 -t 10000 Note: t 10000 means recording for 10 seconds. Users can adjust it according to their own needs.
4）Generate a video taken by the camera, you can use WinSCP software to export the video.

Package includes:
1 x for Raspberry Pi Camera Module
1 x 15pin FPC Cable